Residential and commercial electrical servicesCall (754) 226-1874

Problems

A Downed Power Line at Your Property

A line on the ground, in a tree or draped across a fence or car should always be treated as energized. Stay far away, keep others away, and call 911 and your electric utility. The electrician's work begins only after the utility has made its side safe.

24 Hour Electrician Near Me electrician at work in a South Florida property

Treat every fallen line as live

A wire on the ground does not announce whether it is carrying current. It may be dead, it may be fully energized, or it may switch from one to the other when a protective device on the system tries to restore power automatically. A line that looks inactive, with no sparks, no humming and no movement, can still be lethal. The only safe assumption is that every downed line is live until the utility says otherwise.

This applies to utility lines of every kind: the heavy conductors on poles, the lower service wires that run from a pole to a house, and cable or phone lines that may have fallen across them. Communication lines are often tangled with power lines in a storm, and a cable line that appears harmless can be touching an energized conductor somewhere you cannot see. Do not touch anything that is connected to a fallen line, including a fence, a gutter, a tree branch or a vehicle.

Power does not need to be touched directly to hurt someone. When a live conductor lies on wet ground, current spreads outward through the soil in rings. A person who walks near it can have a different voltage at each foot, and that difference drives current through the body. That is why the instruction is to stay far back, not simply to avoid touching the wire.

24 Hour Electrician Near Me electricians reviewing a commercial electrical panel

What to do in the first moments

Move away from the line and warn anyone nearby. Keep children and pets inside. If you must move away from a line that is very close, shuffle with your feet together, taking small steps without lifting your feet off the ground, rather than taking normal strides. This reduces the voltage difference between your feet if the ground is energized.

Call 911 and report the location and what you see, including whether the line is arcing, whether it is on a car, a fence or a roof, and whether there is any fire or injury. Then call your electric utility's emergency line to report the hazard. In much of South Florida that is FPL, but the service area depends on your address, and your bill shows the right provider. You can report to both, and a dispatcher will coordinate.

  • Do not approach, touch, move or drive over the line
  • Do not touch anything in contact with it, including trees, fences and vehicles
  • Keep others well back and keep pets and children indoors
  • Call 911 first, then the electric utility
  • Do not try to pull it away with a stick, a rope or a tool, even if it appears dry
  • Stay out of puddles and standing water near the line

If a line has fallen on a car with you inside

This is the one situation where the usual advice reverses. If a power line lands on a vehicle you are in, the safest choice is generally to stay inside, keep your hands away from metal surfaces, call 911 and wait for the utility to de-energize the line. Warn anyone who approaches to stay back.

If there is a fire in the vehicle and you must leave, do not step out and touch the car and the ground at once. Open the door, then jump clear with both feet together so that you do not make contact with the vehicle and the ground at the same time, and land with your feet together. Then shuffle away in small steps, without lifting your feet, to a safe distance. This is a last resort, only for a fire or a similar immediate threat.

Never step out to look at the damage, and never let a bystander help you out of the car by touching it. A bystander who touches the vehicle can become part of the circuit.

Whose line is it, and who handles it

The question of ownership sets the order of operations. The conductors on the utility pole, the transformer and the line that runs from the pole to your building belong to the utility, which is responsible for repairing them. Your property typically starts at the point where the service line connects to the mast or the building, though the exact boundary depends on how the service was built and the utility's rules. Our guide to utility meter and service responsibilities explains the typical split.

In plain terms, the utility handles everything up to its connection point, and a qualified electrician handles equipment on your side, such as the mast, the weatherhead, the meter socket, the service entrance conductors and the main panel. If a tree took the utility line down and also pulled the mast off your house, you will have a two-party repair: the utility restores its line, and your electrician repairs the part that belongs to you.

An electrician cannot and should not handle a fallen utility line. Even if a technician arrives and sees a wire down, the correct response is the same as yours: stay clear and confirm that the utility has been notified. If you are not sure whose line it is, treat it as live and report it.

Why you should wait for the utility before any repair work

Repair work on your side cannot begin until the utility has made the situation safe. That may mean cutting the line back, de-energizing the section, or disconnecting your service at the pole or the meter. A utility crew may need to clear fallen trees, set a new pole or restring the service drop before anyone else touches your equipment.

After a major storm, the utility has a very large number of reports to work through, and crews address those with the greatest public danger first. A line in a roadway or across a car is typically prioritized over a line lying in a back yard. That order of priority can feel frustrating if you are the one waiting, but it reflects the real risks and the limited number of crews.

While you wait, keep people clear of the area. If the line is across a driveway or a path, park a vehicle at a safe distance or use obvious markers to warn others, without going near the wire. If neighbors are likely to walk through, let them know. Do not rely on your own judgment about whether the line is dead.

What the electrician does once the utility has cleared the scene

After the utility has made its side safe, a technician assesses what the event did to the equipment on your side. A line that came down on or near your property may have been under strain for some time, and the pulling force that took it down can damage the mast, the weatherhead, the service conductors and the meter socket. Contact with a live conductor, or a surge when power is restored, can also damage the panel, breakers and anything plugged in.

The assessment follows the path of the service from the connection point inward. A technician looks at the mast for bends or cracks, the weatherhead for pulled-out conductors, the meter socket for damage, and the service conductors for stretched or burned insulation. At the panel they look for heat marks, evidence of arcing and breakers that have failed. They also test circuits before recommending that power be restored to the building.

  1. Confirm with the utility which side of the connection point is theirs.
  2. Inspect the mast, weatherhead, conduit and attachment to the building.
  3. Check the meter socket and service conductors for damage or heat.
  4. Inspect the main disconnect and panel for arcing, burns or surge damage.
  5. Test grounding and bonding at the service.
  6. Coordinate permit, inspection and utility reconnection where required.
  7. Advise on surge damage to appliances and electronics.

Mast, weatherhead and attachment repairs

When a line pulls on the building, the mast, which is the pipe that carries the service conductors up and holds the weatherhead above the roofline, is often the weak link. A mast can bend, crack at the roof flashing, or tear away from the wall, taking the weatherhead and conductors with it. The repair may involve replacing the mast, re-flashing the roof penetration so it stays weathertight, and installing new service conductors.

Mast replacement is not a casual job. It involves work at height near the utility's wires, roofing details and a coordinated disconnect, and it typically requires a permit and an inspection before the utility reconnects. Our page on service mast and weatherhead repair explains the work, and the meter socket replacement page covers the next link in the chain.

If the mast has been damaged, also ask the technician to look at the roof where it passes through. Water that gets in at a poorly sealed penetration can stain ceilings and corrode the equipment below, and the roofing contractor may need to be involved.

Hidden damage after a line comes down

A fallen line can send surges into a building before it separates, and the restoration of power afterward can add more. Voltage spikes of this kind stress electronics and the panel itself. Some damage shows immediately, such as a dead appliance or a tripped main breaker, and some shows weeks later as a failing circuit board, a flickering light or a breaker that no longer holds.

If the property was without power, walk through and unplug sensitive equipment before service returns, such as computers, televisions and anything with a delicate control board. Leave one lamp switched on so you can see when power comes back. When power is restored, watch for unusual smells, flickering, warm outlets or a breaker that trips repeatedly, and call for an inspection if any appear. Our pages on surge protection and power flickering after a storm describe what to look for.

If a line fell on a fence, a pool enclosure or a metal structure, tell the electrician. A metal structure that touched an energized line may have carried current to places you would not expect, and the bonding of those structures should be checked.

Storm and tree situations specific to South Florida

In this region, most downed lines follow storms. Hurricane-force winds and tropical storm bands bring down branches and entire trees, and canopy trees such as oaks, palms and ficus can be heavy enough to pull a service drop off a house. Saturated ground after heavy rain loosens root systems, so a tree can fall even in moderate wind. Older neighborhoods with mature trees and overhead lines are especially exposed.

Flooding adds a second hazard. A downed line near standing water is extremely dangerous, and floodwater that has reached a meter, a panel or an outlet can be energized. Do not wade through water near a fallen line or near any flooded electrical equipment. Our guides on staying safe around electricity after a hurricane and electrical safety in a flooded home go through those risks.

Tree trimming near lines is a specialist job for people trained and equipped for it, and the utility manages vegetation near its own conductors. Do not trim any branch that is in contact with, or close to, a service line. If a branch is on the line, treat it as part of the hazard and report it.

Generators and downed lines

After a line comes down, many owners reach for a portable generator. If a generator is connected to the building wiring improperly, it can back-feed the utility line, sending power out onto lines that crews believe are dead. That has killed utility workers. A generator must never be plugged into a wall outlet with a homemade cable, and it must only feed the building through a properly installed inlet and interlock or transfer switch.

If you use a generator, run it outdoors and well away from windows, doors and vents, because carbon monoxide builds up quickly in enclosed spaces. Use heavy outdoor-rated extension cords to power individual appliances if you have no proper connection. Our pages on choosing a generator for your home and portable generator inlet installation explain the safe way to connect one.

If your home has a standby generator with an automatic transfer switch, it should isolate the house from the utility lines automatically. Even so, keep away from the downed line itself.

Documentation, insurance and calling for help

Take photographs from a safe distance of the line, the damage to the mast or building, and any fallen trees. Record the date and time, the report number the utility gives you, and the name of anyone you speak with. Insurance carriers will often ask for these details, particularly if a tree caused the damage. Keep any receipts for temporary measures such as food spoilage or lodging if you were unable to stay at the property.

Once the utility has declared the line safe and you are ready for repairs on your side, call us and describe what you see: where the line came from, what the mast and meter look like, whether the home has power and what the utility has already done. We will explain the next steps, how the quote is given by phone, why complicated work needs an on-site visit and how the service call charge works before anyone is dispatched.

If you are still waiting on the utility and the area is not yet safe, do not call us to cut or move the line. Stay clear, stay informed, and call when the scene has been cleared. When you are ready, call and we will help you plan the repair of your side of the service.

Questions people ask

Can I tell whether a fallen power line is dead?

No. A line can look inert and still carry lethal current, and automatic equipment on the utility system may re-energize a line without warning. Treat every downed line, and anything touching it, as live. Stay far away, keep others back, call 911, and report it to the electric utility. Only the utility can confirm that a line has been de-energized.

Should I call the electrician or the utility first?

Call 911 first for a downed line, then the electric utility, which owns and repairs the lines up to its connection point. An electrician handles the equipment on your side, such as the mast, weatherhead, meter socket and panel, after the utility has made the area safe. Calling an electrician first will not speed up the utility's part.

Is it safe to be in my car if a line is on it?

Generally stay inside, keep your hands off metal surfaces, call 911 and wait for the utility to de-energize the line. If there is a fire and you must leave, jump clear with both feet together so you never touch the car and the ground at once, then shuffle away in small steps. Warn others not to approach.

Do I need a permit to repair a mast after a line comes down?

Mast, weatherhead and service conductor replacements are normally permitted work, and the building department typically requires an inspection before the utility reconnects. Requirements differ by city and county. Your electrician can explain what is usually needed in your area, and the permit office confirms the specifics for your address.

How much will it cost to repair the damage on my side?

Quotes are given only by phone and depend on what the line damaged, such as the mast, weatherhead, meter socket, conductors or panel. Service entrance work usually needs an on-site visit before the scope is confirmed. There is a service call charge for that visit, and it is explained on the phone before any technician is dispatched.

Could my appliances be damaged even if the lights seem fine?

Yes. A line that comes down or is restored afterward can send voltage spikes through the building, and the damage may show up days later as a failing appliance or a flickering light. Unplug sensitive electronics before power returns, watch for warm outlets or tripping breakers afterward, and ask an electrician to inspect the panel and surge protection.

Talk to 24 Hour Electrician Near Me

If "A Downed Power Line at Your Property" sounds like your problem, call and describe what you see, hear or smell at the panel, the outlet or the fixture. We explain what the work involves, and some jobs need a visit before a quote.

Related pages

  • Service Mast Repair: Storm-bent masts and pulled weatherheads: what the electrician repairs, what the utility handles, safety around the line to the house, and how repairs proceed.
  • Meter Socket: Who does what when a meter socket is damaged: the owner, the electrician and the utility, how power is disconnected and restored, and how to plan the repair.
  • After the Hurricane: Post-storm electrical hazards: damaged service equipment, flooded panels, generator misuse, and how to know when it is safe to restore power to a home.
  • Meter Responsibilities: Where utility equipment ends and the property owner's equipment begins at the electric meter, and who repairs what when something is damaged.
  • Damaged Meter Box: A meter box knocked loose by a vehicle, storm or rust is a hazard. Learn what to avoid, who handles which side, and what an electrician checks.
  • Flickering Lights: Why house lights flicker: separating bulb, switch, circuit and utility service causes, and which flicker patterns call for an electrician right away.

Talk through the electrical service you need.

Request service

Related pages

Call (754) 226-1874